DN42 uses network addresses in the [rfc1918](https://tools.ietf.org/html/rfc1918) and [ULA](https://tools.ietf.org/html/rfc4193) ranges. These are described in detail within the sections below.
The [DN42 registry](https://git.dn42.dev/dn42/registry) is the authoritative source of information on address space assignment. Within the registry, the DN42 address space is divided into blocks based on _policies_ that define how the addresses may be used. Policies are defined in `inetnum` and `inet6num` objects and can be:
The [filter.txt](https://git.dn42.dev/dn42/registry/src/master/data/filter.txt) and [filter6.txt](https://git.dn42.dev/dn42/registry/src/master/data/filter6.txt) files within the registry detail the network wide constraints on what address ranges are in use together with the global limits on what can be announced.
`inetnum` and `inet6num` objects within the registry are used to describe the allocation of address space to users. `route` and `route6` objects in the registry are used to validate routing announcements through [ROA](/howto/Bird2#route-origin-authorization).
In addition to the native DN42 address ranges, the registry also contains allocations for the address space used by affiliate networks. These are updated by a regular [sync script](https://git.dn42.dev/dn42/registry-sync).
Globally routable prefixes are not supported in DN42; they are denied via the registry filter{6,}.txt files and many networks will filter both announcements and traffic for prefixes that are outside of the allowable ranges.
DN42 uses the fd00::/8 ULA range for IPv6 addresses. Apart from a block of addresses reserved for anycast (fd42:d42:d42::/48), the whole fd00::/8 block has an open policy and users are free to request any prefix in this range, that is not already allocated.
**The DN42 registry is not authoritative for the fd00::/8 range**
DN42 is interconnected with other networks, like icvpn, which also use the same ULA range and many users will also use this range for their own networks. A registration in the dn42 registry cannot prevent IPv6 conflicts, so a fully random prefix (see [RFC4193](https://tools.ietf.org/html/rfc4193)) is strongly recommended. If an address conflict is found, then needing to renumber your network is no fun.
DN42 uses the 172.20.0.0/14 range for IPv4 addresses. As with the public internet, IPv4 space is more limited and users are encouraged to conserve space where possible. A typical assignment in DN42 is a /27 and any requests for assignments larger than /24 must provide justification.
Unlike the IPv6 address space, the DN42 IPv4 space is not fully open for assignment to users; some ranges are intended for specific uses and other ranges are reserved. See the policy section, below. Users should always check the policy in the registry before requesting a prefix to be assigned.
There are other IPv4 ranges in use within DN42 related to the affiliate networks, see the [filter.txt](https://git.dn42.dev/dn42/registry/src/master/data/filter.txt) file in the registry.
